ACT ACTENTRY A10 Manuel d'utilisateur télécharger pdf (Page 2)

ACTentryA10VR-SK

ACTentryA10VR-FK

ACTentry A10 Operating and Installation Instructions

Installation Notes

• Remember to Factory Default the ACTentry A10 before programming

• Remember to place the supplied varistor across the terminals of the door strike coil to protect the relay

contacts

• Never use the on-board relay to switch AC mains voltage. An external relay, electrically isolated from

the ACTentry A10 should be used for this purpose.

• Remember to change the programming code.

Important

As with any Access Control system, always ensure there is an alternate means of escape in the event of

the unit failing to operate due to power loss or in the event o re.

Product Specication

Number of Users 10 PIN codes

Supply Voltage 12 V AC or DC

Current Consumption 30mA (nominal), 100mA (maximum)

Operating Temperature -10 to +50 degrees C

Door Open Time 0 - 4 minutes

Relay Contact Rating 5A / 50Vac

Controller Size Flush Mount 378 x 144x11mm

Surface Mount: 358 x 125 x 38mm

Water Resistance Medium IP54

Ordering Information

Vandal Resistant Door Entry Panel with integrated ACT 10 Digital Keypad, Call Button

and Speech Unit in a Surface Mount Kit, Door Intercom Handset & Power Supply

Vandal Resistant Door Entry Panel with integrated ACT 10 Digital Keypad, Call Button

and Speech Unit in a Flush Mount Kit, Door Intercom Handset and Power Supply

Vandal Resistant Door Entry Panel with integrated ACT 10 Digital Keypad, Call Button

and Speech Unit for Surface Mounting

ACTentryA10VR-S

ACTentryA10VR-F

Vandal Resistant Door Entry Panel with integrated ACT 10 Digital Keypad, Call Button

and Speech Unit for Flush Mounting

ACTentry A10

Intercom Handset

ACTentry Door Intercom Handset for use with the ACTentry A10. Internal use only.

This is a 1 Amp Power Supply Unit

ACTentry 1A PSU

1 2 3 4 5 6 7 ... 11 12

Pas de commentaire

ACT ACTENTRY A10 Manuel d'utilisateur Page 2